Note: The front 17mm hex adapters are the narrower ones.  You will need the original bearings and install them into the 17mm hex adapters.  You will then use the original front wheel nut to hold the adapter in place on the front axle.  A thin walled wrench might be necessary to lock down the front wheel nut

Note: The rear 17mm hex adapters are wider than the front by 2mm for more wider stance in the rear of your SC10 to provide more stability.  To install, remove the set-screw, slide the 17mm hex adapter over the rear axle (removing the kit spacers and drive pin) and then install the included drive pin.  Once the drive pin is in, re-install the set screw.  A bit of blue lock-tite will help keep the set screw in place

Note:  You have to readjust your slipper clutch once you install the higher traction 1/8th scale buggy tire to prevent snapping the new drive pins
if you want stronger drive pins, MIP/AE C-CVD rebuild kit’s pin are of the right diameter and stronger in material as well.

Comments are closed