Note: Wider hex and the stub axles are for the front, the narrower hex are for the rear

note: to install the front, replace the stock axle with the included stub axles and install the hex adapter on it.  Remove the set screw and put in the original kit drive pin, and then follow with set screw to secure it in place.  A bit of blue lock-tite will help secure the set screw in place.  Install drive pins and set screw the same for the rear.

note: Those running ST3652 series aluminum rear hub carriers will have to do the following:  Do not use any axle washers.  Use Associated drive pins (smaller diameter) especially when using the ST1953 MIP CVD driveshaft kit.

Comments are closed